SUPPORT CENTER

Welcome to Inkbird Support! Any Questions about Inkbird products? We've got answers, and other resources to help you out.

Guide For Inkbird Smart Controller C919

Sensors

Device

1. How to add devices

- Tap “+” button to enter the “Add Device” interface

- Input your Wi-Fi name and password

- Long press “UP” button on the device until its Wi-Fi symbol flashes

- Tap “Start” button and wait a few minutes

4. How to get your slaves

2. How to get your devices

3. How to delete your devices

- Pull down and then release

 Slide left and tap “delete” button

- In the “iDevice” interface, tap a master to enter the “Master” interface and get your slaves which are green.

5. Time mode

- Make your device unplugged in any sensor

- Select this device in the app and enter the “Graph” interface

- Tap “…” button, and set count down time for the device

6. Temperature mode

- Plug a temperature sensor in your device

- Select this device in the app and enter the “Graph” interface

- Tap “…” button, and set parameters for the device

 

Parameter Description:

CF: Celsius or Fahrenheit, default: Fahrenheit

CH: Cool or Heat, default: Heat

T1: Temperature 1, rang: -50~100°C/-50~210°F, default: 24°C/78°

T2: Temperature 2, rang: -50~100°C/-50~210°F, default: 24°C/78°

PT: Compressor delay time, rang: 0~10min

CA: Temperature calibration, rang: -9.9~9.9°C/-15~15°

Master-Slave Switch: If the switch is on, slaves of the master will be setted into temperature mode.

Add Tasks:
- Tap the row of task, enter the “Task Scheduler” interface
- Tap “+” button, enter the “Add Task” interface
- Set all parameters of task, then tap “Done” button

Delete Tasks

- Slide left and tap “delete” button

7.  Humidity mode

- Plug a humidity sensor in your device

- Select this device in the app and enter the “Graph” interface

- Tap “…” button, and set parameters for the device

 

 

Parameter Description:

HD: Humifity or Dehumidity

H1: Humidity 1, range: 1~99%RH, default: 60%RH

H2: Humidity 2, range: 1~99%RH, default: 60%RH

CA: Humidity calibration, range: -15~15%RH, default: 0%RH

8. Cooking mode

- Plug a cooking sensor in your device

- Select this device in the app and enter the “Graph” interface

- Tap “…” button, and set parameters for the device

 

Parameter Description:

CF: Celsius or Fahrenheit, default: Fahrenheit

AT: Alarm temperature, range: 30~250°C/86~482°F, default: 100°C/210°F

CT: Alarm temperature, range: 30~250°C/86~482°F, default: 100°C/210°F

TS: Cooking time, range: 0~999min, default: 0min

Contact Us
Still need help? Our support team is waiting to help you.